Jony

About Jony

This author has not yet filled in any details.
So far Jony has created 8 blog entries.

How to solve the problem of clay leakage on the top of the CERAMBOT extruder.

If there is a clay leakage problem on the top of your extruder, you need to adjust the position of the coupling, increase the distance “a” between the coupling and the motor in the figure, and let the coupling press the silicone gasket. As shown below: At the same time, it is also necessary to

By |2021-04-28T10:43:11+08:00February 4th, 2021|Technology|0 Comments

CERAMBOT Pro Push Rod Motor Problem Summary

1.CERAMBOT worm gear push rod motor running too fast The problem of the speed mismatch between the worm gear push rod motor and the nozzle extrusion motor: When the worm gear reducer push rod motor moves too fast, it will cause too much mud to overflow from the top of the extruder. At this time,

By |2020-12-11T10:44:38+08:00October 23rd, 2020|Technology|4 Comments

CERAMBOT Repetier Control Software Manual

CERAMBOT can not only print via the SD card of the LCD, but also control the print via repeater. (With CURA, CERAMBOT can also be controlled via USB) First download and install repetier: https://www.repetier.com/ Choose the operating system you use, windows, mac or linux. Choose your familiar language, click: ok Next, choose to accept the

By |2020-09-22T12:42:12+08:00September 22nd, 2020|Technology|0 Comments

CERAMBOT Tong | Concrete 3D printing system

        Product description: The concrete 3D printing system uses computer and automation technology to accumulate concrete materials with fast setting and early strength through the outline process layer by layer to realize three-dimensional intelligent paving. It is suitable for research and teaching of architectural 3D printing technology (including design, equipment, materials, etc.).

By |2020-12-13T16:42:29+08:00April 6th, 2020|Technology|2 Comments

How to Convert a FDM 3D Printer to a Clay 3D Printer

CERAMBOT supports conversion of most FDM printers to clay printers. Your device needs to meet the following requirements: 1. You can modify the printer's firmware. If you are using marlin firmware, you need to turn off extrusion protection and add M302 code to Gcode. 2. You need to modify the resolution per second of the

By |2020-10-23T21:30:24+08:00February 25th, 2020|Design, Technology|2 Comments

Clay for 3D Printing

An overview of clay for 3D printing, including guidelines on clay preparation and clay recommendations. This article is adapted from jonathan reservations: HTTPS : //wikifactory.com/@jonathankeep/clay-for-3d-printing Clay for 3D printing All clays can be used for 3D printing, but some clays print better than others . What you are looking for is a less sticky clay

By |2020-02-13T12:18:17+08:00February 12th, 2020|Material|0 Comments

Caring has no border. Sharing is caring

Thanks you everyone support of CERAMBOT in the past two years! Coronaviruses are raging around the world. No one is an island, and mankind is a community of destiny. We are willing to work with you to fight the epidemic, and provide a batch of masks for all CERAMBOT users for free. If you need,

By |2020-05-16T09:27:34+08:00February 1st, 2020|Uncategorized|0 Comments

Title

Go to Top